Nippondenso Starter for Chevrolet Gmc Vauxhall

All planetary cycloidal reducer gear can be divided into three parts: input parts reduction output section on the input shaft is equipped with a displacement of 180 double eccentric sleeve, turn on the eccentric sleeve is equipped with two called arm of roller bearing, the formation of H institutions two cycloid gear center hole is the eccentric sleeve on the turning arm bearing raceway, and by a group of cycloid gear and pin gear mesh circular permutation needle, to form tooth difference for the internal meshing gear reducer is organization,( 1437669,in order to reduce friction, in the speed reducer ratio is small, the needle with needle teeth on the gear set)

When the input shaft with eccentric sleeve rotation for a week, because of the characteristic of the cycloid gear tooth profile curve and its restricted by needle on the gear teeth, the movement of the cycloid gear becoming both revolution and rotation of the plane movement, turn on the input shaft is week, eccentric sleeve also turn the week, Cycloidal Wheel turned a gear reduction is obtained in the opposite direction, and then with the help of W output mechanism, the cycloid gear rotates at low speed movement through the pin shaft.

Output Shaft

Output Shaft,Output Shaft of Cycloidal Pinwheel,Output Shaft of Transmission Gear Motor

JiangYin JiaYou Reducer Co., Ltd. , http://www.general-reducer.com