Toyota Sequoia Maintenance – Replace Brake Pads

Is it time to replace your brake pads in your Toyota Sequoia? Follow these steps to get it done.

Replacing Front Brakes

Here's how to tackle replacing the front brakes:

1. Start by engaging the parking brake to ensure the vehicle stays stable.
2. Remove the hub cap by locating the notch near the lug nuts and unscrew the lug nuts.
3. Lift the Sequoia with a jack and secure it with jack stands. Remove the tire completely.
4. Identify the front brake calipers and locate the three pins or springs securing the brake pads. Carefully remove these pins from both sides of the pads and move them aside.
5. Before taking out the pads, use a flathead screwdriver to push the brake pistons back into their housing.
6. Gently pull out the old brake pads after ensuring all pins and springs are out of the way. If they’re stuck, you may need to drain some brake fluid from the master cylinder.
7. Install the new brake pads, ensuring they're properly seated. Consider applying a brake lubricant to reduce noise.
8. Once the new pads are in place, reinstall the pins and springs.
9. Ensure the rotor is aligned with the wheel before mounting the tire back on.
10. Secure the wheel and tighten the lug nuts gradually—start by hand tightening them.

Replacing Rear Brake Pads

For the rear brake pads, follow these steps:

1. Make sure the emergency brake is disengaged. Also, secure the front wheels with wheel chocks to prevent the vehicle from rolling.
2. Locate the notch in the hub cap cover and remove the lug nuts.
3. Lift the vehicle and stabilize it with jack stands. Remove the wheel.
4. Unscrew the two bolts (17mm) located on the back of the caliper and gently slide it off.
5. Hang the caliper loosely from the axle using zip ties if necessary, but avoid twisting the brake lines.
6. Remove the old brake pads either by hand or with a screwdriver.
7. Install the new brake pads, ensuring they match the original design, especially the brake indicator tab.
8. If needed, use a tool like a screwdriver or C-clamp to push the pistons back into the caliper housing.
9. Reinstall the caliper and tighten the bolts securely.
10. Finally, mount the wheel back on and tighten the lug nuts.

Congratulations! You’ve successfully replaced your Toyota Sequoia brake pads. If you encounter any difficulties or need further assistance, don’t hesitate to consult with a professional mechanic or your local dealership.

Remember, regular maintenance not only keeps your vehicle safe but also helps maintain its value over time. Whether you're working on the front or rear brakes, always prioritize safety and take the necessary precautions to avoid accidents.

Bimetallic Screw And Barrel

Bimetallic Screw And Barrel,Ni-Based Alloy Barrel,Bimetallic Barrel,Alloy Screw And Barrel

Zhejiang Guangming Plastics Machinery Co.,Ltd. , https://www.gmscrews.com