Configuration method and installation technology of spiral beneficiation equipment

When using spiral beneficiation equipment, the configuration must consider the size of the white to facilitate installation, maintenance, and proper use of the site. This configuration is reasonable if the distance between individual spiral beneficiation equipment can be replaced.

When designing a concentrator, the slurry of the selected material should be considered for self-flow without the use of a centrifugal pump for feeding in and out. When installing equipment in an existing company, it is possible to use a pump to transport material.

Spiral equipment is mostly installed in rows because it allows for reasonable use of the site area and allows the same product to be collected into the aggregates mounted below the equipment or combined under the lower elevation platform. This can shorten the length of the pipe selection. The three-head spiral beneficiation equipment with a 120 degree lower end of the spiral groove is required to operate from the side. This type of screw can also be installed in rows, but in order to facilitate the operation of the equipment, the rows must be kept at a certain distance. In this case, the product is discharged separately from the spiral groove, and the combination is only required to be below the elevation.

The configuration of the spiral beneficiation equipment is mostly determined by the span of the production plant. The span of the production plant is mostly 6x6 or 6x9 meters. The span of the ore dressing section of the ore dressing plant is usually a multiple of 6 or 3. The equipment should be adapted to the arrangement of the columns, so that the front is not located on the main corridor, so that it will not hinder the operation.

Several options for the configuration of spiral beneficiation equipment. When configuring the equipment, consider leaving a wide passage to ensure that the spiral beneficiation equipment can be transported on the aisle. At the same time easy to operate. The channel width is considered to be 750-1100 mm.

Customed Railway Construction Power Pack

Jiangsu Guorui Hydraulic Machinery Co., Ltd , https://www.grhcn.net